Setting Up Your Foaming Pressure Sprayer

Our Foaming Pressure Sprayer is tried and tested by professional detailers the world over, offering the ultimate detailing product for use with ready-to-use, spray-on cleaning agents like Citrus Power Bug & Grime Remover and Total Interior Cleaner, along with all dilute-to-suit cleaners such as Imperial Wheel Cleaner, Verso All Purpose Cleaner and Dynamite Traffic Film Remover.

What’s even more special about this product though, is that it can also be adapted to create a thick lingering foam, making it ideal for applying Avalanche Snow Foam, particularly when a Snow Foam Lance isn’t available, if perhaps you’re detailing on the go or looking to perform a Safe Detail At Your Local Jet Wash.

But most importantly, you don’t need to buy any separate accessories or attachments to get foaming away on every car wash, because the Foaming Pressure Sprayer comes complete with everything needed to set it up for both types of application.

Let’s have a look at how you can set up yours for every detail…

Setting up for use with spray-on cleaners...

Whether it's a wheel cleaner or a pre-cleaner, when you're looking to atomise your cleaning agents for quick and even application (without foaming them up) the Foaming Pressure Sprayer is super quick and simple to get ready for the task in hand.

Here there's only two attachments needed - the non-foaming siphon pipe, and adjustable spray nozzle - the one with the blue tip.

The first thing to do is check that you have the correct siphon because the Foaming Pressure Sprayer is supplied with a different pipe essential for both set ups. The non foaming pipe has a strainer cap, here its pictured on the left.

The pipe should be pushed into the bottom of the spray head, it only fits one way, with the strainer at the bottom.

All that's left is to screw on the adjustable spray nozzle, and you're ready to get to work...

Fill the bottle with your cleaner of choice, dilute if necessary and refit the trigger head.

Now all you need is a few pumps to build up the pressure and you can apply your cleaning agent to the vehicle.

Setting up to apply snow foam...

It's also quick and simple to set up our Foaming Pressure Washer to apply your Avalanche Snow Foam, here's how it's done...

This time there are three essential parts that help your Foaming Pressure Sprayer create a foamy constancy that lingers to break down bonded dirt and grime. These are the foaming siphon pipe, the foaming nozzle and a special grommet that makes the magic happen...

First we'll set up the adjustable foaming nozzle which locks in the grommet. You'll need to unscrew the spray nozzle first if it's fitted. Then you can fit the grommet, sliding it into the screw fitting with the thinner end first.

Next we can screw on the adjustable foaming nozzle.

Finally, after removing the non-foaming siphon pipe if you have to, slide the foaming pipe into the hole in the bottom of the trigger head.

Now you're ready to fill the bottle with your Avalanche concentrate.

Pour 2-3cm of Avalanche concentrate into the Foaming Pressure Sprayer bottle, top up with water and screw on the trigger head. Now you can give it a few pumps and apply your snow foam for the ultimate, and most importantly safe, pre-wash.

Remember that the foaming nozzle is also adjustable allowing it to tailor the application exactly to your needs.

And that's all you need to know to get your Foaming Pressure Sprayer set up for every detail. Simple, eh?

For more product guides and how-to features be sure to visit the Guides Section Of Our Blog.